Question: Where do you connect the timing light?

How do you put a timing light on a coil pack?

How do we get the timing light to flash?Attach the clip over the ignition output between the ECU and the ignition module.Remove a single coil on plug setup from the engine and add an old spark plug lead between the coil and spark plug.Hold the clip open and make it “bite” the top of a coil on plug setup.

How do you use the electronic timing light?

0:313:14How to - Tune your Ignition // ToolPRO Timing Lights - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd attach the inductive clamp to the number one ignition lead. Now start the car and the time andMoreAnd attach the inductive clamp to the number one ignition lead. Now start the car and the time and life will begin flashing. Point. The light at the timing mark on your crankshaft pulley or flywheel.

How do you use a coil tester?

2:213:41Cylinder Misfires & Ignition Coil Testing - YouTubeYouTube

Contact us

Find us at the office

Hurtarte- Aminov street no. 34, 93309 The Valley, Anguilla

Give us a ring

Oluwadamilola Gleich
+93 552 509 928
Mon - Fri, 8:00-17:00

Tell us about you