Question: How do you set up a beginners skateboard?

What skateboard should a beginner start with?

To start with, we recommend a deck width of 7.75 or 8.0. Most full-sized complete skateboards will come in either 7.75 or 8.0 widths, this is the right size to start with, as your experience grows youll know if you need a wider board later on.

How do you set up a skateboard?

Step 1: Attach Grip Tape to Deck. Place your deck on a flat surface so the nose and tail ends are facing up and the graphic on the bottom of the deck is facing down. Step 2: Mount Trucks to Deck. Step 3: Install Wheel Bearings and Attach Wheels to Trucks. Step 4: Test Your Skateboard.

How much does a beginner skateboard setup cost?

Average skateboard setup costs run a little under $170. As you can see, the deck and trucks bring prices up. Least expensive setups can cost around $64-$ if choosing to build your own complete.

Is it hard to assemble a skateboard?

Assembling your skateboard isnt difficult once you understand how all the parts work together. Start by applying the grip tape to the deck, then screw in your trucks, and finally add the wheels and bearings.

What is a reasonable price for a skateboard?

Classics can cost from $60-$400. A classic, cruiser, or mini cruiser is good for cruising, and you can still do tricks at the skatepark with this one. Street/verts can cost from $70-$200. Theyre the typical skateboard, mostly made for tricks but good for a little bit of everything depending on the wheels.

Are Penny boards good for beginners?

Suitability Of The Penny Board For Beginners They are good for easy skating and casual rolling around to get a hang of the concept. They are good for learning the foundational skating basics like balancing, pushing, turning, etc. You can learn major tricks like cruising and tight carving over its.

Which way do skateboard trucks face?

Difference between Skateboard Trucks andLongboard Trucks: Longboard trucks are usually reversed kingpins (the center bolt on which the hanger pivots), meaning the kingpin faces outwards. Standard kingpin trucks for short boards sit with the screw facing inside to protect it from grinds and whatnot.

Can you put a skateboard together without a skate tool?

You can use a skate tool or the axles of your trucks to pop them in place, make sure you put them in all the way, they shouldnt stick out. You should also use spacers to protect your bearings from getting crushed when you tighten the axle nut. Tools you need; A skate tool or your hands and your trucks axle.

How much is too much for a skateboard?

A high-quality skateboard costs about $170 on average. This is when you pay full price for high-quality components, name brand wheels, trucks, and bearings. But if youre smart with money, you can get that down to around $120. You can also get a good deal on a complete and not have to spend as much.

Do penny boards break easily?

Since penny boards are plastic, its not easy for them to snap or break. So, while penny boards dont break easily, they do occasionally break. Like with skateboards, lower-quality penny boards are more likely to break than a higher-quality penny boards.

Are penny boards worth it?

There is nothing wrong with Penny Boards — they are a short, cheap board BUT Penny Boards are not a good board choice for most people in most riding scenarios due to their small size. Penny Boards arent bad, they just are not as versatile as a longboard or a skateboard for transportation.

Contact us

Find us at the office

Hurtarte- Aminov street no. 34, 93309 The Valley, Anguilla

Give us a ring

Oluwadamilola Gleich
+93 552 509 928
Mon - Fri, 8:00-17:00

Tell us about you